CPD valve (crankcase pressure dump valve), fit this instead of a new breather, includes 4 clips.
See all the details below - but just keep your old breather in place and put this metal valved unit into the rubber tube from it.
Gives a huge increase in crankcase depression.
An old engine will often be covered with oil on the outside and drips on the ground.
The apparently simple engine breather, when in working condition (they dont last forever, say - 5 yrs. maximum), creates a partial vacuum inside the crankcase which means that at the point of a potential oil leak the engine tends to suck air in rather than leak!
If you open the lid of the breather with engine running oil and fumes will always gush out - that is normal! On each down stoke of the piston any air inside the crankcase is compressed, if pressure cannot escape the resulting power loss can be 2bhp. (5mph from top speed, 6mpg consumption increase). Fitting new often improves starting too!
Part Number: 00358
£37.00
Reviews
Current Reviews: 1
Customers who bought this product also purchased
- Product DescriptionPrice
-
Flanged nut, set of 8 to hold both front wings of 2cv to body£3.91
-
Metal clip, holds door board trim to door interior. EACH£1.48
-
Rubber only, for 2cv front over rider.EACH£5.75
-
Oil filter, genuine PURFLUX, for 602cc 2cv etc.£5.90
-
Pair of floors, zinc plated steel for 2cv6, good quality, limited time offer.£82.21
-
Bump stop, square, beneath front arm on chassis side.£5.09